The device with analog output 0(1)–10 V is used to control devices, luminaires, thermal actuators, and thermal heads – which are equipped with such an input.
They can be combined with detectors, controllers, iNELS Wireless, or system components.
Potential free analog output 0(1)–10 V, contact relay 8 A.
7 light functions – smooth increase or decrease with time setting 2 s–30 min.
The analog controller may be controlled by up to 25 channels.
The programming button on the controller is also used for manual control of the output.
Memory status can be pre-set in the event of a power failure.
Range up to 200 m (in open space), if the signal is insufficient between the controller and unit, use the signal repeater RFRP-20N or protocol component RFIO2 that supports this feature.
The BOX design lets you mount it right in an installation box, a ceiling, or a light cover.
TECHNICAL PARAMETERS
Output: 0(1) - 10 V / 10 mA
Supply voltage (frequency): AC 110-230 V (50/60 Hz)
E-shop
English GB
Česky
Slovensky
English
Deutsch
Polski
Български
Magyar
Românește
Tiếng việt
Ukraine
Español
Српски
